6 Tricks to Having The Correct Door Lock Maintenance

The door lock is one of the frequently used features of the house if not the most. Most homeowners, though often forget that just like any other tool or feature, door locks to need maintenance to continue being of excellent service to the house. A lot of the door lock failures may be due to its improper installation or lack of proper maintenance, even if, it is of decent and quality make. An experienced Toronto locksmith at Lock-up Services Inc can offer you with professional help if faced with any difficulties during lock installation.

Door locks will forever work efficiently happens to be a widespread belief among many homeowners. The highest quality of hardware locks can even get working for decades and decades, but that will depend on the frequency of use and how it is maintained. Locksmith experts have it that the lifespan of an average door lock is approximated to seven years.

This guide got your back in maintaining your door lock. Below are some of the significant six factors you should consider having your door lock serve you for more years.

  1. The door should be hung properly

Proper installation and correct preparation of the door lock is the only way to have a door lock functioning correctly. Sagging or binding of the door places a vast pressure amount to the latch of the lock or the bolt and a result, it may end up leaving one locked inside or outside of the house till it is fixed. A door that is appropriately hung should not bind, and the gap length between the frame and the door should be estimated to be equal to the sides and the top. The best measurements should approximate not more than an inch and lesser than a fifth of an inch.

  1. Have the strike plates and the door screw’s checked

There should be more than one screw that their primary purpose will be to secure the top hinges and the doorframe. The screw is expected to be of a good length, well enough for the door to connect the wall that frames on the door. It is recommended that homeowners should add a longer screw for prevention of sagging of the door and increase the break-in ability of resistance. The length of the screw should be approximately three to four inches to the hinge. The screws should put just at the wall’s center as the hinge screws remain staggered.

More attention should also be on the strike plate. It should be appropriately secured using long screws on the wall framing.

  1. Be sure that your dead latch and deadbolt are working correctly

A deadlatch is a tiny plunger that always rides on the flat side of the lock. It is of importance to make sure that the deadlatch does not enter in the strikes of the plate. The reason for this is because it is a security feature and is designed mostly on modernized entry door locks that if not appropriately aligned with the striking plate, it will not function well. A broken, deadlatch will often cause improper functioning of the bolt.

The deadbolt in a typical situation should freely operate when the door is closed. It is not necessary to pull, lift or push the door for the lock to work. Make sure that the hole of the deadbolt on the doorjamb to be deep for allowance of the bolt extending entirely. The deadbolt is not locked not unless it is extended fully. You can always contact your local locksmith to counter check the deadlatch.

  1. Make sure to have your door locks cleaned well

Maintain the external parts of the lock does not entail much effort. It requires one using a detergent that is mild for the door lock cleaning. A deep-damp piece of rag can also be used.When a chemical or abrasive cleaner is used on the door lock, it does more harm than good. The same also applies to products made from petroleum.

  1. Annual lubrication of the door locks

Lubricating the door locks is among the critical door lock maintaining factors as well as the most ignored. Some of the best lubricants to use on the door include Teflon and graphite. This is because of their ease to apply. It is healthy to have your door locks lubricated once in a year, at least.

  1. Have the original door lock key duplicated

Another door lock maintenance factor is having the key and maintaining it. Often do door lock keys wear out faster before the door lock itself does. Have an extra key, among the primary keys that come with the lock, set aside to use for duplicate creation.